View Full Version : micro switch for bushy?
Soopa Villain17
04-01-2005, 02:11 PM
ok ive seen people selling them some places and the package there in says radioshack, there the 25 g switches, any no the numbers or anything so i can go over there and buy one? thanks
Big Weapons
04-01-2005, 02:54 PM
www.paintballtrader.com
Very bouncy switch though -- make sure you set a sufficient debounce value or you'll have a runaway gun.
Soopa Villain17
04-01-2005, 02:57 PM
yea but i aint paying 7 bucks to have something shiped when i go to radioshack
Big Weapons
04-01-2005, 03:43 PM
Your choice. If you have eyes, make sure you ground the wires properly.
Soopa Villain17
04-01-2005, 03:46 PM
yup ive got eyes :tard: , why ground it isnt it already grounded
Big Weapons
04-01-2005, 08:07 PM
A couple of PDS wires are attached to the switch. I'm not particularly sure how the wiring works so I'll stop here.
madmolly
04-01-2005, 08:14 PM
Man seriously don't dick with the switch. The stock switch is fast enough just practice a little. It is generous enough with bounce that with a little practice you can outshoot a halo. I would not start tearing it up for a new switch they are a pain to put in bushys.
Big Weapons
04-01-2005, 08:29 PM
Depends on your trigger. My microswitch pins were really easy to remove with just a roll of tape, a hammer, and a nail. Of course, you might end up ripping a few wires out of their solder joints [ICD harnesses aren't the best in quality].
Soopa Villain17
04-01-2005, 08:40 PM
ok well i messed with the trigger stuff and made it super light i can walk it so i guess i wont buy a new switch yet , ill fokus on the important stuff thanks guys
kenndogg
04-02-2005, 03:40 AM
[ICD harnesses aren't the best in quality].
that sir is an understatement
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.