Mr. BoBo
04-17-2005, 03:15 PM
So I have a left feed ULE warp body and your stock warp hose.
I have a problem where the warp hose and fitting will slide off the body if there is too much pressure. I was hoping the connector to body would be a snug fit but it's fairly loose.
Any ideas or suggestions other than duct tape?
I have a problem where the warp hose and fitting will slide off the body if there is too much pressure. I was hoping the connector to body would be a snug fit but it's fairly loose.
Any ideas or suggestions other than duct tape?