Retro Valve double-firing

[froggie]

Hi everyone, I am having a little trouble with my retro mag in that it fires twice with each trigger pull. I don't mean that the balls are double-feeding but that my gun will fire once when the trigger is pulled back and then again when the retro valve kicks the trigger back out. While it does raise my rate of fire I wish to have more control over the number of times my marker fires and am seeking any input you guys can give me. My setup is a retro mag with intelliframe and a flatline tank running at about 800 psi input pressure if that helps. Thanks everyone in advance :D

[z_mann_z]

You have a sear or bolt problem. If you have changed the sear rod length, put it back where it was. I f it is not this, the sear or bolt may be worn out. Also check the on off to make sure it looks okay.

[PyRo]

Do you have an auto response frame?

[froggie]

I don't think so, just a regular intelliframe.

[PyRo]

Probably sear or bolt problem then.

[Load SM5]

You may also want to try turning your input pressure down a bit. I've occasionally gotten an accidental double tap at 750. Blame it on the nice light reactive trigger.