Aliens-8-MyDad
05-20-2005, 03:37 PM
well after someone seeing a picture of my e-mag and noticing the custom carved trigger someone from ao (Emert426) just had to have it done :) heres what I came up with.
http://xbcustoms.com/images/trigger1.jpg
http://xbcustoms.com/images/trigger2.jpg
http://xbcustoms.com/images/trigger3.jpg
http://xbcustoms.com/images/trigger4.jpg
here is the order in which I did it.
benchgrinder-remove the mass of it and get the shape
dremel with some of those like rock grinding heads-get deep cuts out left from the benchgrinder
150 grit sandpaper-smooth it
220 grit sandpaper-smooth it more
320 grit sandpaper-smooth it even more
600 grit sandpaper-smooth it than before get out lines
1000 grit sandpaper-remove all visible lines and make it sliky smooth
mothersmag+polishing wheel-make it shine like chome.
http://xbcustoms.com/images/trigger1.jpg
http://xbcustoms.com/images/trigger2.jpg
http://xbcustoms.com/images/trigger3.jpg
http://xbcustoms.com/images/trigger4.jpg
here is the order in which I did it.
benchgrinder-remove the mass of it and get the shape
dremel with some of those like rock grinding heads-get deep cuts out left from the benchgrinder
150 grit sandpaper-smooth it
220 grit sandpaper-smooth it more
320 grit sandpaper-smooth it even more
600 grit sandpaper-smooth it than before get out lines
1000 grit sandpaper-remove all visible lines and make it sliky smooth
mothersmag+polishing wheel-make it shine like chome.