Just got my X mag Problem!!

[X mag owner]

I have a problem with my Xmag I am hoping somebody will know how to fix it. When I pull the trigger it doesn't shoot very fast like it kinda takes a while for it to shoot and when it does it usually goes full auto. The trouble shooting guide say its a too short on/off pin . I beleive this is the prob. When I push down on the seer with my finger it works perfect. How do you adjust it? Any help would be most apperciated!!

[Dayspring]

Measure your on/off pin with a set of calipers. But it should be .712".

[X mag owner]

I musured it a t work with a pair of digital calipers and its .712 any other adjustments or suggestions that might help cure this problem?

[Hotshot33610]

Oil and O-rings seems to fix about every other problem with a mag. I constantly get told to make sure my on/off is well lubed.

[mcdkid]

charge the battery, and then make sure the magnet on the back of the trigger is adjusted right. also do all this in e-mode so its not the sear kicking in while your working.

[athomas]

Check the battery and its connections as well as the PC board ground connection. This should eliminate any voltage concerns that may play a part in erratic behaviour. Other than that, clean the valve inside and out. Make sure the sear rotates properly. Make sure the solenoid plunger rod is not bent. Check for debris anywhere in the body of the gun.

[X mag owner]

I know this is a total newb question but what kind of oil like a synthetic pball oil or like a light lube like dow 33? Thanks for all you r help!! I have enever owned a agd before so I have know idea lol

[Dayspring]

Gold Cup/KC/Autolube. Any of those work. Dow33 won't.

[RazorMonkey]

For mags, oil, not grease...