PDA

View Full Version : maxflow problem kinda


Gumbe
05-29-2005, 09:55 AM
i have an old maxflow(not sure of the year) and it has a tank on it that i would like off but it wont come off..no matter how hard i try what can i do?
CrimsonGhost
05-29-2005, 10:02 AM
Take it to a Scuba shop or ...Airsmith to have it removed.
They both have the proper tool to remove stubborn regs.

:cheers:

By the way ...hehe...Is it a 1st gen MAX FLOW or a later version?
Im looking for a 1 st gen reg "cap" (only has the 1 hole for the bleed off)

:cheers:
Gumbe
05-29-2005, 10:17 AM
umm ok sorry if i dont make sence


you screw in the tank then theres a gage then it goes down to another tube like aread then a gage and then a hole at the tip lol sorry
CrimsonGhost
05-29-2005, 10:20 AM
Hehe, SOrry I was the one that wasn't clear.

I am talking about the end cap ...the adjuster Does it have just the hole where the copper colored filter is at the very end , OR does it have multi holes along the cap?
Gumbe
05-29-2005, 10:46 AM
lol oh ok where the fitting goes in it is on the right hand side then on the top of the adjuster theres a hole and also on the left hand side to
Automaggot68
05-29-2005, 11:59 AM
Bring it to your local shoppe.

Edit:
Hell you know what?
Listen to the above buffoons and tell us later what happened.
Make sure there's air in your tank when following their directions.

/end sarcasm