View Full Version : Classic Valve on RTP rail?
Any of you guys give this a try? I would think you would need a longer on/off pin but I dunno....
Jonno06
05-30-2005, 11:49 AM
rtp's have a banjo bolt, which im 90% sure would get in the way.
Any of you guys give this a try? I would think you would need a longer on/off pin but I dunno....
rtp's have a banjo bolt, which im 90% sure would get in the way.
rtp's do not have a banjo bolt. Rt's do... Come on man you have like 4k posts
Tigwldr
05-30-2005, 12:00 PM
I am thinking of doing this very same thing. What would need to happen or this to work? I hope there is a way to do it. Would the rail need to be modified or something.
I am thinking of doing this very same thing. What would need to happen or this to work? I hope there is a way to do it. Would the rail need to be modified or something.
no it will bolt right on, what I am concerned with is the length of the on/off pin. not sure if the stock classic is long enough. There should be some old AO dude that can answer this question.
Tigwldr
05-30-2005, 12:08 PM
I am very new to Mags so I am not sure what the on/off pin is. I have seen a pic somewhere in all my searching the last few weeks with the very setup we are discussing but I am not sure where I saw it or whos it was.
lbonettosd
05-30-2005, 12:50 PM
To the best of my memory, I believe you will need an on/off pin that is .765" instead of the stock .750". Of Course I could be wrong.
Tigwldr
05-30-2005, 12:58 PM
Do you have a picture of this pin and where it goes? Where do you find these parts at? Can I get one from AGD or do I have to post wanting to buy?
Jonno06
05-30-2005, 01:02 PM
sorry about the mix up, its been awhile since ive had a mag.:)
CoolHand
05-30-2005, 01:27 PM
It will work just fine.
If you use the ULT, you will have to retune it, but I have run Classics on RTP rails many times, with the stock On/Off, and never had a problem.
personman
05-30-2005, 01:29 PM
Just put the rtp on/off in the classic valve
dynastyfan
05-30-2005, 01:32 PM
thats how i ran my mag when i had the rtp rail. it worked fine no problems what so ever. but i have since moved over to a mm rail for size and different body
It will work just fine.
If you use the ULT, you will have to retune it, but I have run Classics on RTP rails many times, with the stock On/Off, and never had a problem.
has anyone tried milling out the on/off section to except the ult. I have run a ULT before and it barely fit back into the body.
Destructo6
05-30-2005, 02:31 PM
I have a Classic valve on a Rogue RTP rail and it fits and functions quite nicely.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.