Siress
06-23-2005, 10:34 PM
I promised to post my findings, and here they are.
I snagged the Check-it Spyder trigger as the Dragun Stick trigger I KNOW had to fit perfectly is no longer made. So, I grabbed what I could and started modifying it.
After cutting off the extension on top that's made as a pre-travel adjuster I had to sand down the hump on the back to correspond with the Hyperframe. Then I drilled the trigger pin holes to 1/8" (which only took .005" from the trigger and about .03" from the frame) and got a 1/8" pin cut to fit. Simply clamp about 1/8" long of the pin into a vice and squish the sides out a bit so it grabs onto the frame. After that all that was left to do was sand the top to make the prefect pre-travel stop. (There's plenty of room to add a set screw below the trigger pin hole on the trigger to have it adjustable) There is already a post-travel adjustment screw, but my set-up doesn't need it. Oh, and the trigger switch I'm using is from Chris at Devils Den, it's the same as the Devil Mags use.
Here's the result:
AT REST:
http://tinypic.com/692kn8.jpg
ALL THE WAY BACK:
http://tinypic.com/692l93.jpg
Disclaimer: Although I posted about the trigger pin I have not in fact done that yet, I don't have an 1/8" rod stock...well...in stock. But I know it will work, I do it frequently for other guns.
I snagged the Check-it Spyder trigger as the Dragun Stick trigger I KNOW had to fit perfectly is no longer made. So, I grabbed what I could and started modifying it.
After cutting off the extension on top that's made as a pre-travel adjuster I had to sand down the hump on the back to correspond with the Hyperframe. Then I drilled the trigger pin holes to 1/8" (which only took .005" from the trigger and about .03" from the frame) and got a 1/8" pin cut to fit. Simply clamp about 1/8" long of the pin into a vice and squish the sides out a bit so it grabs onto the frame. After that all that was left to do was sand the top to make the prefect pre-travel stop. (There's plenty of room to add a set screw below the trigger pin hole on the trigger to have it adjustable) There is already a post-travel adjustment screw, but my set-up doesn't need it. Oh, and the trigger switch I'm using is from Chris at Devils Den, it's the same as the Devil Mags use.
Here's the result:
AT REST:
http://tinypic.com/692kn8.jpg
ALL THE WAY BACK:
http://tinypic.com/692l93.jpg
Disclaimer: Although I posted about the trigger pin I have not in fact done that yet, I don't have an 1/8" rod stock...well...in stock. But I know it will work, I do it frequently for other guns.