going to set my RT ON FIRE! AGD TECHS HELP!

[RSUAVE911]

Ok I have two problems with my gun

1)
For some reason the balls are not feeding into the barrel correctly, IT IS LIKE JAMMING in the frame, its like the balls are not fitting almost into the hole where the barrel and frame meets. I am sure its not the balls...It either has to be the stock barrel(trying to get a new one), plug(which I think might be it), or the frame itself.

2)
I have put a shortened on/off pin in, and after I rapid fire it leaks, I would have to apid fire for like 2 or 3 times and then it would start.

(PS- I attached a pic, so maybe it might be my setup)

SO PLEASE ANYONE HELP! email me or reply

RSUAVE911@AOL.COM

[RSUAVE911]

picture

[RSUAVE911]

SORRY NO PICTURES SOMETHING IS NOT WORKING RIGHT..SORRY


UP

[BlackVCG]

Try this, with balls in your hopper feeding into the gun, and the plug turned so balls can go in the breech, slightly pull back on the plug until the balls drop in the barrel, or the plug comes all the way out of the mainbody.

Also, try fitting the paint to your barrel. If the paint is so big that it can't go through the barrel, that's a problem.

Do you have a longer on/off pin? When's the last time you've oiled your valve?

[RSUAVE911]

Ok as for the feeding problem I think I have it resolved because I have an older power feed plug instead of the newer parabolic PF Plug...


Yes I do have a longer one and I just oiled it today.

plmk..thanks