PDA

View Full Version : trigger pin on Pro-Team frame


dolphin1823
08-10-2005, 02:09 PM
Hey all, I've got a Pro-Team double finger trigger, and the trigger pin (the metal pin that holds the trigger in the frame) is real easy to push out. Infact if I turn the frame horizontally and tap on the frame I can get the trigger pin to fall out. Any suggestions? Will loc-tight work? Theres no threading so I don't know.

Thanks,
Kevin
KayleAGD
08-11-2005, 07:09 AM
Hey all, I've got a Pro-Team double finger trigger, and the trigger pin (the metal pin that holds the trigger in the frame) is real easy to push out. Infact if I turn the frame horizontally and tap on the frame I can get the trigger pin to fall out. Any suggestions? Will loc-tight work? Theres no threading so I don't know.

Thanks,
Kevin


take out the pin and use a sharp (hard) center punch and make a small punch mark on one end . This will make the pin bind in the frame .