autococker question.....

[chefstevie]

i have an older wgp cocker....i dont know if it is a 99 or 2000+
i need to know because im making a sniper out of it (pump)
so any help would be apreciated...thanks

[coofoo777]

if you post a pic it might be easier to figure out...

[VFX_Fenix]

Things to look for.


1) Hammer Lug Timing Hole - This will be a small hole in the top of the body between the feed neck and the rear of the body between the grooves sof the site rail - If it doesn't have this your Cocker is pre 96 or 97

2) Square Sight Rail Ends - The sight rail that's milled into your body will either have a square end right over the barrel or it will be milled down at a shallow angle, the rear will also either be sqare or be radiused, if your sight rail has the angle and radius, it's a 99, if it doesn't, it's a 98.

3) Back Block - 2000 Back Blocks are around 3/4" thick while 99 blocks are closer to 1.25" thick

4) Banjo Bolt - The Front block will be held on by a Banjo Bolt whick is around 3/8" in a 99, the 2K+ bolt will be larger (on the order of 1/2"+)

[chefstevie]

ok it has a 2000+ backblock but a 99 body....thanks guys