omni
12-06-2001, 07:29 PM
I just got my Mag, WOO!
One thing thats a tad weird on it tho is the valve area, I can push it snug up against the body fine, but when I put the screw in (the one that goes thru the back of the trigger frame), it will only go in if I let the valve body out a bit about .2CM, ok I know its not much, but its still not lining up like it should. (So its not fitting right up snug with the body, you can see a gap)
http://models.firearmsmod.com/images/omni/screw.jpg
Right where the arrow points is where it is, and the lettering on the Reg doesn't match right up, this might be is, like the A.I.R part, the A is not lined up right, but I don't havea clue how to move the two parts.
Now that I got my Mag, I know about all those parts you guys are talking about, like those nubbins, had no IDea waht they were, before I saw the nubbins in my barrels, I got wire ones, how do I try those rubber ones out?
One thing thats a tad weird on it tho is the valve area, I can push it snug up against the body fine, but when I put the screw in (the one that goes thru the back of the trigger frame), it will only go in if I let the valve body out a bit about .2CM, ok I know its not much, but its still not lining up like it should. (So its not fitting right up snug with the body, you can see a gap)
http://models.firearmsmod.com/images/omni/screw.jpg
Right where the arrow points is where it is, and the lettering on the Reg doesn't match right up, this might be is, like the A.I.R part, the A is not lined up right, but I don't havea clue how to move the two parts.
Now that I got my Mag, I know about all those parts you guys are talking about, like those nubbins, had no IDea waht they were, before I saw the nubbins in my barrels, I got wire ones, how do I try those rubber ones out?