View Full Version : flatline 4500
AGD Mech Pride
10-03-2005, 02:02 PM
Where can i find directions on adjusting the flatline?
I know I've seen them on AO before but couldnt find them when i searched today so can anyone post a link thanks.
Dayspring
10-03-2005, 03:40 PM
Adjusting as in raising or lowering the output pressure?
That's simple. Look at the front of the reg. Take your 1/8" allen key and insert it into the hole. From this point on, it's like any Mag valve. Clockwise = higher, counterclockwise=lower.
Be sure to tighten the nut back down to lock the adjuster in place.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.