Vicious6
10-10-2005, 06:41 PM
First off I'd like to say hello and introduce myself a little. I know many AO members personally but finally have taken the time to join the community. I usually am involved with unofficial woods events in the northern NJ area. While using mostly low-end mechs my whole life (except for my ATS AT85 :D ), I finally purchased my first mag a few months ago. ....I also promptly started dumping money into it. I have a Tac-One with Q-loader, Freak kit, ULE trigger and PMI 88/4500 tank. Needless to say, I've become a mag freak and don't much care for anything else.
Second, I sincerely apologize if this has been an overdone topic, but I've just finished doing 2 hours of searching and haven't found the information I need!
I wanted to start on my own little project mag. A rough idea of what I would like would start with a Minimag body, adding lvl10 and Xvalve internals. Also, I'd want to get my hands on one of the more recent hyperframes. I was thinking of a warp feed, but I'm trying to keep it as compact as possible. My barrel of choice would be another freak kit with a flashpoint tip. (I'm a sucker for freak barrels) I'd probably want to run it remote to a PMI tank. I'm not into flashy annodizing, the stock grey body is good for me. Possibly with some shiny stainless or black pieces, but that's about it.
Again, I'm sorry if this is a played out topic, but just couldn't find what I needed. Any information on how to go about this, tips on a better setup, or direction towards a thread that has some good pointers would be greatly appreciated!
PS: Hope to see many of you at AONJ; I just happen to live in West Milford (unfortunately), so I will definately be there the 22nd! :cheers:
Second, I sincerely apologize if this has been an overdone topic, but I've just finished doing 2 hours of searching and haven't found the information I need!
I wanted to start on my own little project mag. A rough idea of what I would like would start with a Minimag body, adding lvl10 and Xvalve internals. Also, I'd want to get my hands on one of the more recent hyperframes. I was thinking of a warp feed, but I'm trying to keep it as compact as possible. My barrel of choice would be another freak kit with a flashpoint tip. (I'm a sucker for freak barrels) I'd probably want to run it remote to a PMI tank. I'm not into flashy annodizing, the stock grey body is good for me. Possibly with some shiny stainless or black pieces, but that's about it.
Again, I'm sorry if this is a played out topic, but just couldn't find what I needed. Any information on how to go about this, tips on a better setup, or direction towards a thread that has some good pointers would be greatly appreciated!
PS: Hope to see many of you at AONJ; I just happen to live in West Milford (unfortunately), so I will definately be there the 22nd! :cheers: