View Full Version : how low can you go?
rkjunior303
10-12-2005, 09:13 AM
Thanks to Caz @ Paintball Wizard here in MA for doing the feedneck milling.. Oh, I can't wait for my new Halo shell, so I can cut it down :)
http://gankish.net/~rkjunior/dm4_nopro.jpg
TheTramp
10-12-2005, 09:22 AM
You are raging out of control!
LudavicoSoldier
10-12-2005, 10:05 AM
Holy crap! Thats pretty freaking low!
mag88888
10-12-2005, 10:06 AM
i want mine like that.
MicroMiniMe
10-12-2005, 11:38 AM
I'm thinking eventually someone will make a marker with a clamping breach itself, no profile and just a small tightening nut on top.
slade
10-12-2005, 02:25 PM
Oh, I can't wait for my new Halo shell, so I can cut it down :)
so THATS why you want that new halo...
I'm thinking eventually someone will make a marker with a clamping breach itself, no profile and just a small tightening nut on top.
...and then the feedneck breaks, and you have to replace the whole body.
FooTemps
10-12-2005, 02:55 PM
so THATS why you want that new halo...
...and then the feedneck breaks, and you have to replace the whole body.
...and that's why we have modular breeches.
Creative Mayhem
10-12-2005, 03:31 PM
that looks crazy rob!
Kevmaster
10-12-2005, 03:33 PM
...and that's why we have modular breeches.
or why we make feednecks that dont break because its part of the body
cdacda13
10-12-2005, 05:45 PM
If you have rip drive, its going to be hard to use it with the feedneck that low.
BD_Paintball
10-12-2005, 05:49 PM
If you have rip drive, its going to be hard to use it with the feedneck that low.
i was thinkibng the same thing but im sure you will still be able to do it. that does look really good.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.