deded
12-07-2001, 04:40 PM
I have a minimag, and the screw that goes into the vertical ASA doesn't seem to want to come out.
Do they use loctite on this screw at the factory?
Should I put some heat on it and then try?
Or should I just be a man and twist harder :)
The reason I want to take it off is to flip it backwards, so the steel braided line is on the right instead of the left.
I need to do this because I got a new minimag valve, and the quick male quick disconnect thing is on the right... as my old one was on the left...
Is there another way to solve this problem? or should I flip over the ASA like I was going to?
Thanks!
Do they use loctite on this screw at the factory?
Should I put some heat on it and then try?
Or should I just be a man and twist harder :)
The reason I want to take it off is to flip it backwards, so the steel braided line is on the right instead of the left.
I need to do this because I got a new minimag valve, and the quick male quick disconnect thing is on the right... as my old one was on the left...
Is there another way to solve this problem? or should I flip over the ASA like I was going to?
Thanks!