View Full Version : X-mag problem
JESTER22
10-25-2005, 04:53 AM
I have an X-mag that does not fire all the time on electic mode. the battery is fully charged it will fire a couple of shots the stops then starts firing again. it seems as if the battery is very low or flat. but checked the volts and it is fine put it on another e-mag and it is working fine so it is not a battery prob.
any ideas anyone? :confused:
athomas
10-25-2005, 07:48 AM
Check you wires. There could be a pinched wire somewhere. Also, check the screw holding the board to the frame. Clean it out to make a good electrical connection.
Also, check your trigger settings. Maybe your trigger magnet has shifted or your stop point is too close to the actuation point.
Demonio
11-11-2005, 04:35 PM
Did you check your ACE Setting?
0- for off
1- Solid 1 color balls
2- 2 color balls
and or you may want to adjust the ACE sensitivity
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.