PDA

View Full Version : Dumb question - is a micromag feedneck removeable


Lohman446
12-23-2005, 09:29 AM
On the vertical feed micromags is the feedneck threaded and removeable? What thread?
rkjunior303
12-23-2005, 10:02 AM
No, it's not.. but I've found, at least on my old Micro-E, it fit an unsanded reloader b PERFECTLY.
Lohman446
12-23-2005, 10:05 AM
No, it's not.. but I've found, at least on my old Micro-E, it fit an unsanded reloader b PERFECTLY.


Answer I wanted for the no too. Thank you
BobTheCow
12-23-2005, 10:22 AM
No, it's not.. but I've found, at least on my old Micro-E, it fit an unsanded reloader b PERFECTLY.
Whoa, really?

Hello new Reloader B!
rkjunior303
12-23-2005, 10:26 AM
I mean, I could still spin it but it fit snuggly enough in the cup that it wouldn't go anywhere unless I really grabbed it. The depth is deep, too, so you don't have to cut the neck. I liked it..
UTDragun
12-25-2005, 11:11 PM
halos/reloaders use the exact same shells so a halo would fit unsanded too.

just to keep it even ;)

but reloader has cooler looking shells
SpitFire1299
12-25-2005, 11:53 PM
halos/reloaders use the exact same shells so a halo would fit unsanded too.

just to keep it even ;)

but reloader has cooler looking shells
I thought the reloader was slightly bigger. :ninja: :tard: