Body doesn't fit a lv 10

[angelpena]

I have an SS Rpower feed body that is perfect for my warp feed, but the only problem is the BOLT doesn't fit inside the body. I'm thinking this may have been either a rental body or maybe just a very old body. any thoughts?

[Dayspring]

It may be that there is a burr on the inside ring where the bolt spring will rest. May need to file it down a pinch.

[angelpena]

it is definitely the bolt. I have a L7 bolt in my parts box and it fits the body with no problems.

The L10 bolt is just too "fat" to fit through the ring on the inside of the body.
I also tried one of my other L10 bolts and am having the same problem.

I don't have a micrometer otherwise I would compare the two.

[KayleAGD]

It may be that there is a burr on the inside ring where the bolt spring will rest. May need to file it down a pinch.


yea, what he said... the constant hammering over the years will mushroom the ring in the mainbody and roll a burr into the inner diameter, a small file or a sanding disk will remove a very small ammount of material do the bolt will slide into the breech..

[angelpena]

Ok I see what you guys are saying, I'll give that a shot this weekend!

Thanks a lot!

[angelpena]

Just a few spins with a brake cylinder hone and I am back in business! That was it! i knew I could count on the Mag geniuses here to get me going again!

a million Thank yous!

I'll take a pic and post it here!

[angelpena]

Here she is! I have a Mini body but I really didn't lie the looks of it, and this body fits pretty good with my warp. I was bummed when the bolt didn't fit, and tossed it in my parts bin for about 6 months. Thanks again!


http://img.photobucket.com/albums/v369/angelpena/WarpedBrassr.jpg
http://img.photobucket.com/albums/v369/angelpena/WarpedBrassl.jpg
http://img.photobucket.com/albums/v369/angelpena/AGDBrassL.jpg