punkncat
01-03-2006, 10:48 PM
Well I have been at it again.....I took a perfectly good ZeroB boarded Worrlock autococker and turned it back into a mechanical.
I decided to use mostly WGP parts to make myself a "super stock" of sorts. I did opt for a better HPR than the Black Magic, a lighter bolt, and I went with a Bomb 3 way. It already had the Orry internals, and came with a Kaner kit so there was no real need to change those. I decided to keep the Eblade sear lug. The flat end makes for a very short crisp sear release early in the trigger movement. In conjunction with the bomb 3 way I have the travel down to about 1/4 of an inch at the bottom of the trigger, maybe a bit less.
The timing is so close that after you fire it actually sucks a piece of tissue down onto the feedneck rather than blowing it away. I am fairly easily outshooting the feed rate of my 12V Revi.
I will get some picture up here in a bit.
I decided to use mostly WGP parts to make myself a "super stock" of sorts. I did opt for a better HPR than the Black Magic, a lighter bolt, and I went with a Bomb 3 way. It already had the Orry internals, and came with a Kaner kit so there was no real need to change those. I decided to keep the Eblade sear lug. The flat end makes for a very short crisp sear release early in the trigger movement. In conjunction with the bomb 3 way I have the travel down to about 1/4 of an inch at the bottom of the trigger, maybe a bit less.
The timing is so close that after you fire it actually sucks a piece of tissue down onto the feedneck rather than blowing it away. I am fairly easily outshooting the feed rate of my 12V Revi.
I will get some picture up here in a bit.