My Drawing For E-mag Dye Stickys

[RaV3n_Pa1ntba||]

Ok here is a little prototype drawing.... For my Dye E-Mag Sticky Grips. If anyone is good at melting rubber who could fill in the middle hole and drill the other two out I would pay good money for them. But must have a chrome like panel backround with sticky grips over it. (as shown in drawing)
TX

Its not my best work but its noy too bad anyway.....Enjoy

[RaV3n_Pa1ntba||]

Pic

[FooTemps]

I don't see the pic!

[RaV3n_Pa1ntba||]

next try

[X-Plosive]

they look nice and clear, so clear they almost look invisible. While we're at it can you reduce your sig image at all? It takes up 60% of the page...that's just not cool. I'm using a common resolution too. I tried PMing you but something went wrong:(

[FooTemps]

I don't know but I don't see it still. It just shows the message and nothing else. Wanna try attaching it instead?

[RaV3n_Pa1ntba||]

this is all i could think of because i dont have photoshop on my comp once again im too lazy to install it ;)

[BlackVCG]

I already posted in another thread about you reducing your sig image. Please do so. Thanks.

[RaV3n_Pa1ntba||]

cant dont have adobe...but can anyone see the pics here..because i think they might be too high quality if you can please make it the right size etc. And then post the grips here...as for the sig images cant do no adobe...maybe you can like save them yourself resize it and email it to
[email protected]