PDA

View Full Version : Need pump mag info


dockman
01-28-2006, 06:01 PM
I was lucky enough to get mt hands on a pump kit for my mag but I need a little info so I can get it put together. Dose anyone have detailed diagram or specs for where the main body needs to be milled for the pump kit to work? Or if someone knows a shop I could send it to that can mill it for me?

Any information would be appreciated.
cougar20th
01-28-2006, 06:20 PM
email me at cougar20th at hotmail. and ill email you back the info your looking for.
dockman
01-28-2006, 06:31 PM
email me at cougar20th@hotmail.com and ill email you back the info your looking for.

Email sent, thanks.
cougar20th
01-28-2006, 06:57 PM
Email sent, thanks.

replied. congrats on getting the pump parts. they are fun to use
hs2000
10-07-2006, 11:27 PM
email me at cougar20th at hotmail. and ill email you back the info your looking for.

Could I get some of that info? I am assuming your selling the millings? email me, Alexsteege@hotmail.com
phizz
10-08-2006, 02:13 AM
check this out http://airsoldier.com/~haveblue/tech/automag/index.html not sure if it will help or not.
hs2000
10-08-2006, 08:20 AM
check this out http://airsoldier.com/~haveblue/tech/automag/index.html not sure if it will help or not.

I have looked a that a half dozen times now, but it doesn't tell me the dimensions that the body needs to be milled.
RRfireblade
10-08-2006, 10:23 AM
I have looked a that a half dozen times now, but it doesn't tell me the dimensions that the body needs to be milled.

The body just needs to be relieved enough to clear the pump arm. It's not a critical DIM.
cougar20th
10-08-2006, 05:05 PM
the info that is on airsolder is what i had sent to dockman. i then sent it to haveblue who put it on airsolder.
doc_Zox
10-08-2006, 08:01 PM
this should help:
http://premium1.uploadit.org/docZox//pumpmag.jpg
hs2000
10-08-2006, 08:18 PM
wow, thanks a lot. That's a big help. Judging by the picture the 5 mm slot isn't very deep, but it seems to get deeper as you move towards the opening, that's not how it has to be right? What's the reasoning why you did it that way?
Thanks again, it's really helpful.
doc_Zox
10-08-2006, 08:24 PM
i bought a used mag on here and thats the body that was on it

i'm pretty sure from the look of the milling, that that is an AGD factory pump body

the ramped slot looks like typical Tom Kaye attention to detail

;)
doc_Zox
10-08-2006, 08:28 PM
http://cgi.ebay.com/AUTOMAG-PUMP-BODY-MINIMAG-AGD-E-X-MAG-PAINTBALL_W0QQitemZ320034854506QQihZ011QQcategoryZ 36285QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

$57.50 and one can be yours
hs2000
10-08-2006, 08:31 PM
^no way, I got to have center feed.
mpsd
10-12-2006, 07:50 PM
this should help:
http://premium1.uploadit.org/docZox//pumpmag.jpg

Do you have this for the pump rod as well?

Thanks!