Direct Intellifeed from E-Mag to Revvy

[ZeroXtreme]

I've been searching through the forum, and I can't find any instructions on how to do the intellifeed link from the E-Mag's Warp-out terminals directly to the X-board of the Revvy, or maybe to the Revvy's sensor PCB. There must be some way to do this without having to buy a Warpfeed's PCB like Rob documents on his site (http://www.robagd.com).

Help, anyone? :confused:

[headcase]

Just an idea, but if you splice the two wires in the emag to warp harness into the two wires going to the board from the eye it might work. I haven't tried it out yet, and please don't take my word for it.

Anyone else have an idea.

I have a spare Revy harness, so when I get my warp I'll try it.

Later
SSDD

[ZeroXtreme]

Thanks for the tip, I was thinking the same thing, although I don't want to experiment since I might fry something.
I'm more or less looking for step-by-step instructions and diagrams from someone who already did it.
I'm not too scared of frying my Revvy's board, I'm actually teriffied of frying my E-Mag's PCB!