Machinist Help

[Chaos_Theory!]

Im not sure if this is the correct place ot put this so please lmk if i need to delete it or anything.

Anyway, im going to be getting a new frame for my ion soon and im going to do a mod that requires a hole be drilled in the ASA for the standard .125 OD cocker or small ion hose to fit through. As i have no ready access to a drill press or any other machinery at this time i need some help. If anyone on here knows someone who is or is well known for doing good clean machine work please lmk.

Below is a pic of what i need done. The hole i need drilled is the one in the upper right hand corner on the front of the ASA. Thanks

http://i8.photobucket.com/albums/a5/Adrenaline_Junkie/asamod.jpg

[PnueMagger]

A multi speed dremel can do that. I built an entire pnuematic frame using only a dremel. Just use pleny of cutting oil and the right speed.

Edit: BTW, what mod?

[bleachit]

Luke

www.lukescustoms.com

[Chaos_Theory!]

I found someoen to do it and i considered Luke.

A dremel is not an option. I want the hole to be as clean as possible and if i mess up i cant get a new ASA.

Im going to be doing the LPr mod to my ion.

[PnueMagger]

I found someoen to do it and i considered Luke.

A dremel is not an option. I want the hole to be as clean as possible and if i mess up i cant get a new ASA.

Im going to be doing the LPr mod to my ion.

explain this mod, what is done?

[Chaos_Theory!]

This should explain it all, if you have any other questions please lmk and i will help you.

http://www.zdspb.com/customwork/ionlpr.html

The way im doing the mod is a lot cleaner but it still works the same.