Stopping emag bounce...

[hobbesTZ]

I'm having trouble getting my emag to stop bouncing. When I pull the trigger normally one shot at a time it doesn't bounce, but if I pull it slowly it goes off in 2 or 3 round bursts. I've adjusted the SHBF between 4 and 100 and it didn't help anything. Any suggestions?

[Dayspring]

Hybrid or E mode?

[hobbesTZ]

E mode.

[hobbesTZ]

It's probably worth noting that when you pull the trigger slowly without gas you can hear it clicking in bursts just like when it's gassed up, only it seems to be a little worse.

[Z-man]

See if the sear pin is touching the trigger in E-mode. That will do it.

[Dayspring]

The magnet may be on the bleeding edge of detection by the HES. Try giving yourself a little bit more back travel or move the magnet closer to the HES in the trigger.

[Tunaman]

Also, try reversing the solenoid wires. 3.2 is known to have this bug...

[Arstron]

I am not sure how it works, but is it possible he has the jumper for 3 round burst?

[Dayspring]

That function was taken out in 3.2, which is what he has.


I am not sure how it works, but is it possible he has the jumper for 3 round burst?

[hobbesTZ]

I messed around with the magnet and it's still going off full auto. I assume that means I need to send it in to AGD to swap the wires since my soldering skills aren't up to par.

[REDRT]

I messed around with the magnet and it's still going off full auto. I assume that means I need to send it in to AGD to swap the wires since my soldering skills aren't up to par.

I'd send it to Tuna sence he is closer to ya.

[hobbesTZ]

It's all fixed, I just had to swap the wires. Thanks a bundle guys :headbang:

[Tunaman]

:D