PDA

View Full Version : Screw size and small problem


flyboy
04-23-2006, 10:42 AM
I just bought a used Emag. The manual says is an RT ULE for waht its worth.

Does anyone know the sze of the front triger frame screw? It's either got the wrong on in it or something is stripped since it wont tighten.

Also the rear trigger thumb screw is finger tight as suggested by the previous owner. When I air the gun up it starts firing in full auto mode even the the emag turned off. Any suggestions of whats wrong?
Dark Frost17
04-23-2006, 11:33 AM
10-32 threads i belive i dont rember the lenth...
some 1 tell me if i am wrong... :D
flyboy
04-23-2006, 01:21 PM
The one I have is 13/16 and seems too short.
flyingpootang
04-24-2006, 06:07 PM
The one I have is 13/16 and seems too short.

Hmmm. On my X and ULE RT it's 10/32. Best thing to do is find the correct diameter and hold the teeth together. If they mash together then it's the same thread pitch. Or go buy a pitch gauge...