View Full Version : wall thickness for 500psi
superfreakmabsta
05-05-2006, 09:27 AM
i am trying to make a part for my automag and i am trying to figure out how thick to and internal air passage way. basically how thin can i make the walls of a preasure holding air to maintain a high saftey factor and still get a large volume. i want to be able to run up to 500psi into it and i would like to construct it out of aluminum. any help the good people of AO can offer would be great.
RapidTransit
05-05-2006, 10:16 AM
i am trying to make a part for my automag and i am trying to figure out how thick to and internal air passage way. basically how thin can i make the walls of a preasure holding air to maintain a high saftey factor and still get a large volume. i want to be able to run up to 500psi into it and i would like to construct it out of aluminum. any help the good people of AO can offer would be great.
http://www.matweb.com That site should provide you with the info you seek.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.