nak81783
12-19-2001, 09:15 PM
I am getting a small nitrogen tank for use on my automag. I'm going small because I'm also getting a scuba tank and fill station. I've done quite a bit of research, but I still cannot decide which way to go. I'm either gonna go for the 51 cubic inch Crossfire 3000psi or a 48 cubic inch PMI. I have a few concerns I'd appreciate some feedback on.
1. I've read the Crossfire tanks have a better recharge rate. Is this true?
2. I've read that the threading on the Crossfire tanks is brass (very soft) and bends or breaks very easily. Any truth to this?
3. On which brand is the reg and valve assembly longer?
4. I've heard PMI has the better gauges. Is this true?
Thanks,
Nathan
1. I've read the Crossfire tanks have a better recharge rate. Is this true?
2. I've read that the threading on the Crossfire tanks is brass (very soft) and bends or breaks very easily. Any truth to this?
3. On which brand is the reg and valve assembly longer?
4. I've heard PMI has the better gauges. Is this true?
Thanks,
Nathan