PDA

View Full Version : would this work?


Dark Frost17
05-21-2006, 06:59 PM
would this work for the mag frames.....

http://cgi.ebay.com/UNIVERSAL-Trigger-pin-NO-MORE-HAMMER-Smooth_W0QQitemZ7222962346QQcategoryZ87120QQtcZpho toQQcmdZViewItem
Pyroboy597
05-21-2006, 07:05 PM
Yea I would assume so, but the point is to prevent trigger stops from scratching the frame of your gun. Unless you have a weird trigger (not an AGD-made one) you don't have trigger stops.
Dark Frost17
05-21-2006, 07:20 PM
its not a trigger stop....... :rolleyes:
its fot the pin that the trigger swings on.....
RRfireblade
05-21-2006, 07:36 PM
I'd assume that you'll have to drill larger diameter holes in the frame and trigger but seems like it would work.
SpitFire1299
05-21-2006, 07:37 PM
Send them an email. :)
Pyroboy597
05-21-2006, 07:43 PM
My bad, I thought it was one of those nylon trigger stop covers that I got for my ion. The stock Ion triggers have metal stop screws that after a while chisel off the black anno where they hit, so I picked up a little cover that fits on the end of it to stop that.
Dark Frost17
05-21-2006, 07:53 PM
My bad, I thought it was one of those nylon trigger stop covers that I got for my ion. The stock Ion triggers have metal stop screws that after a while chisel off the black anno where they hit, so I picked up a little cover that fits on the end of it to stop that.

No problem...

Does any one know the size of the pin or the hole? :confused:
TheGrindPunk
05-21-2006, 08:10 PM
you can find those at most machine/industrial hardware stores like grainger.......(that is if you have a grainger near you...... you could try their website http://www.grainger.com).
A while back I bought a dye frame for one of of my spyders, I lucked out and got one of the bad batch ones where dye thought it would be a good idea to tap everything 1mm too big..... and one of those things worked out real well. I got one at a grainger about 10mins from my house (and for a lot less than that guys whats for them..... they're only a couple bucks). All it is, is a shoulder screw and a standoff/sleeve.


I don't know if it is different on other frames, but the trigger pin on the CF frames are like 1/8".
st6212
05-21-2006, 10:21 PM
No problem...

Does any one know the size of the pin or the hole? :confused:

It says the hold in the frame must be a minimum of 0.660 of an inch wide.

Wonder if you need to mod the hole in your trigger also?
RRfireblade
05-22-2006, 02:09 AM
It says the hold in the frame must be a minimum of 0.660 of an inch wide.

Wonder if you need to mod the hole in your trigger also?

That's the length of the pin not the width of the hole.

.660 of an inch is like 5/8" , that'd be one heck of a larger pin. ;)
st6212
05-22-2006, 02:36 AM
My bad...didn't read that part properly :D
Dark Frost17
05-22-2006, 05:40 AM
i belive the right name for it is a sex screw or a sex bolt.... :)
i was hoping i wouldent have to mod anything