View Full Version : Please Help - Logo Alignment Problem
aenima4six2
12-20-2001, 10:39 PM
Ok my problem is quite simple, my 68 Auto MaG logo does not line up, ive tried straighting it, but the screw will not thread unless it is slightly off. 2nd, when i do line it up pretty close, then get it screwed in , it comes un-alligned slightly. Is this a problem ?
a_malfunction
12-20-2001, 11:40 PM
Nope.... It happens. Not a problem. If it is WAY off you could have something wrong with it, but if it is just a bit off, its ok.
Miscue
12-21-2001, 01:31 AM
Yep... samething he said. :)
aenima4six2
12-21-2001, 08:30 AM
its about, at most an 1/2 an inch off, probably around 1/4th though
Cha0tic
12-21-2001, 08:45 AM
replace the body o-ring. this will help keep it screwed on better. i used to have a similar problem.
aenima4six2
12-21-2001, 09:14 AM
its brand new, just got it yesterday though
If you take the valve out, there is a little grove in the back of the rail. On the reg itself is a little pin which slides in that grove, be sure that it is on there.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.