SummaryJudgement
06-17-2006, 06:56 PM
Hey guys,
I recently got a BPS Twister cocker body and am assembling a new gun. It had all matching annoed parts (except backblock). I went and got a complete Belsales frontblock set-up for it, but it wont fit because the frontblock hole is way too small. Laughing I didn't even think about the body differences, stupid me. So I'm going to have to transfer all the parts from the frontblock they came onto my existing one. RED THREAD LOCKER!!! Everywhere. I'm sure I'll be able to get the parts out of the frontblock, I've only been successful with the ram so far.
So, what I need to know is:
Would the twister body be a pre-99, or 2k body type?
I got a freeflow bolt without paying attention and it's not the right length either Crying or Very sad
Pffft! I just got a little excited about a new project and didn't pay attention to anything. However, I now have some new parts for other "project" guns I never got around to finishing.
Any input would be appreciated.....
Yes, I know this is a Mag forum......
I recently got a BPS Twister cocker body and am assembling a new gun. It had all matching annoed parts (except backblock). I went and got a complete Belsales frontblock set-up for it, but it wont fit because the frontblock hole is way too small. Laughing I didn't even think about the body differences, stupid me. So I'm going to have to transfer all the parts from the frontblock they came onto my existing one. RED THREAD LOCKER!!! Everywhere. I'm sure I'll be able to get the parts out of the frontblock, I've only been successful with the ram so far.
So, what I need to know is:
Would the twister body be a pre-99, or 2k body type?
I got a freeflow bolt without paying attention and it's not the right length either Crying or Very sad
Pffft! I just got a little excited about a new project and didn't pay attention to anything. However, I now have some new parts for other "project" guns I never got around to finishing.
Any input would be appreciated.....
Yes, I know this is a Mag forum......