Pneumagger
07-09-2006, 06:22 PM
I was thinking of using an Emag on off in a mech mag. Can this be done safely? Also, will it be more reactive and have too short of a pull? Will the buna nitrile oring hold up better than the standard teflon orings? Will the shorter pin cause runaway?
The reason I'm doing this is because I'm getting lot's of chuffing/half cycles at higher rates of fire around 13bps. I cant seem to tune it ay better. Could the tigger stops be causing this? They are set up stop the trigger just a little after the marker fires. What can I do to tune the ULT better...does it really just not recharge as fast?
The reason I'm doing this is because I'm getting lot's of chuffing/half cycles at higher rates of fire around 13bps. I cant seem to tune it ay better. Could the tigger stops be causing this? They are set up stop the trigger just a little after the marker fires. What can I do to tune the ULT better...does it really just not recharge as fast?