CCM Heli-Clamp Feedneck, reloader-b

[retread]

Does anyone know if the CCM Heli-Clamp Feedneck will fit the empire reloader-b without any sanding or grinding of the reloader-b?

[StygShore]

Yes it will, I just used a Karta with one on it this weekend

Styg



Does anyone know if the CCM Heli-Clamp Feedneck will fit the empire reloader-b without any sanding or grinding of the reloader-b?

[mag_lover05]

i have one and an un-sanded halo B w/ rip. works fine

[SummaryJudgement]

Same here....

[retread]

Yes it will, I just used a Karta with one on it this weekend

Styg

I am confused with the feed neck rises. I have an empire reloader-b that I do not want to have to modify (ie. cut or sand etc...) but would still like a relatively low profile. What would you suggest?

[StygShore]

The rise has nothing to do with the feed neck on your Halo. The cup is pretty much the same size on all of the CCM feeds, its just the height of the pipe underneath the cup.

Go with the No-Pro if you want the lowest profile. You MAY have problems wiht the No-pro on a Karta body because of th emilling ont he body around the feed neck.


Styg

[SpitFire1299]

I have a no-rise, no-pro.. and i cut it and it works great too.

[SR_matt]

the no pro requires you to cut it shorter then no rise does not. both have no rise under the neck but the nopro ends up shorter since it does not hold the whole neck
-matt