CO2 Problem

[iambored]

I got my first mag today and decided to gas it up and when I screwed in the co2 tank it didn't stop leaking :eek: and I tried another and the same thing I think it is the o-rings are dried out and too tight but, could it be the agd bottem line? :confused:

[iambored]

And It leaked out the bottom line (not the hose, strait out the back around the tank)
My current solution is on/off pmi tank and on/off direct mount cp bottom line

Anyone got any suggestions other than HPA?
:confused:

[Ace12GA]

New bottom line ASA time. Of course bad tank o-rings would do this too.

[doc_Zox]

And It leaked out the bottom line (not the hose, strait out the back around the tank)

unless the threads are seriously damaged

it sounds like a 15 cent O ring will stop the leak

[CoolHand]

Drop an extra tank oring into the ASA before you screw on the tank.

Back in the day this was called the MaxFlo mod, since SP was too stupid to machine the little nubbin in their manifold MaxFlo's the correct length. They were always too long, so you needed an oring in there to get it to seal.

That should take care of your problem.