hyperframe troubles

[eric_503]

so i got my hyperframe in and with the stock on/off assembly and mech trigger frame it doesnt leak but when i put the centerflag on/off in it and the frame on it leaks down the barrel and the sear doesnt activate the soloniod(spelling?)

so does this mean
A i need powertube spacers or
B a longer on/off pin

also is there anyway i can fix it with what i have since im in the part of canada of which there are only 3 mags(including mine:()

[flyingpootang]

I use an RT type on/off with a .712 pin My settings are 3, 1, 5. With a ULT my settings are 2, 1, 5....

[eric_503]

this hyper frame has the 20 bps board ive got shot counter what its capped to and a game timer i guess

[nevtangle]

this hyper frame has the 20 bps board ive got shot counter what its capped to and a game timer i guess
Try looking at the Hyperframe FAQ. http://www.automags.org/forums/showthread.php?t=79328&highlight=hyperframe+faq
What kind of valve do you have?
To change your settings you need to enter the service mode. Read the FAQ.

[eric_503]

ive got a minimag valve thanks for the thread (im learning new things :p )

[Coralis]

more than likely the on/off oring on the hyperframe on/off valve needs replacing.

[eric_503]

ok i'll try that and also i take it these have to have the 2 orings in the bottom like all mags do? (the white oring and the other tanish peachish kinda colour i guess it would be)

[flyingpootang]

Using the stock hyperframe on/off usally results in a "Self Destruction" problems see here: http://warpig.com/paintball/technical/etriggers/cflagmag/index.shtml Thats why a ULT or RT with a .712 or .750 pin will work the best.....See hitech's post on tuning the on/off pins. If you need step by step help pm me with where your at and I'll walk you through each step. 20bps hyperframes are very fast and will give you a ramp effect if set up propperly....

[flyingpootang]

Another good tread on a 20 bps classic valve: http://www.automags.org/forums/showthread.php?t=201202

[Coralis]

I run a ult in my hyper mag with two shims and the level 10 works like a charm, it also worked in my other valve (rental) with a level 7 bolt

[eric_503]

ive always had bad luck when it comes to valves;)

i had a colonial once and it gave me nothing but trouble it had all the oldschool mods in it tho (8 hole in the reg) tiny bits and pieces gone for weight all the aftermarket stuff you could do to a mag valve yet it sat so long i could never get it to hold air properly(reg seat was toast and it leaked down the barrel (sometimes with the trigger down sometimes not)

[pump]

if you need a new pin RT On Off Pins fit!!!

i use a .770 with my hyperframe On Off.....the turned down part of the RT is a bit thick compared to Hyperframe's but some sanding and polishing can make it smaller....but dont do it too much

[eric_503]

is there anyone in canada thats a tech and i could send it to or atleast some here i can send it to and get it tuned and done (shipping the whole gun over the border takes a long time and could get taken away)

[AnthonyDStone]

Just us an R/T style on/off pin and a 9.6VRecgargeable battery,Make sure the on off is lubed,Settings at 6-20-10.Worked for me always.

Tony