PDA

View Full Version : Question about my new emag...


SureLockRTPro
08-26-2006, 01:31 PM
What do i need to buy to fit m RT Pro valve into my emag? Or can i use the valve the way it is? I'm planning on purchasing an x valve later on but i dont have the money to right now...

-donald
gibby
08-26-2006, 01:44 PM
Did you just buy the lowers or as a whole? If whole, it should have already came with an RT Pro valve. Also, you should be able to just slap your RT Pro valve in if it doesn't already have one.
SureLockRTPro
08-26-2006, 01:51 PM
this is what i bought right here...

http://cgi.ebay.com/ws/eBayISAPI.dl...AMEWA%3AIT&rd=1
JRingold
08-26-2006, 03:31 PM
What do i need to buy to fit m RT Pro valve into my emag?

Nothing.
A-Tach-One
08-26-2006, 03:39 PM
Or can i use the valve the way it is?

You will need an EMag on/off pinand a quad oring. It is a bit shorter then the RT pin and measures .712 in length.
JRingold
08-27-2006, 12:41 AM
You will need an EMag on/off pinand a quad oring. It is a bit shorter then the RT pin and measures .712 in length.

Ahh, he said RT Pro. I was thinking X-Valve, would the On/Off still need to be changed if he had an X-Valve?
Mayzons
08-27-2006, 12:45 AM
Ahh, he said RT Pro. I was thinking X-Valve, would the On/Off still need to be changed if he had an X-Valve?
just the on/off pin and add the quad oring,the on/off is the same just the pin length and quad oring is different
A-Tach-One
08-27-2006, 12:53 AM
just the on/off pin and add the quad oring,the on/off is the same just the pin length and quad oring is different
Correct, the Xvalve on/off pin is still to long at .750, so needs to be changed to work in the Emag. The length of the Emag on/off pin is at .712. :cheers: