View Full Version : rt valve and x valve
randel
09-20-2006, 06:03 PM
i was just wondering if there is any diffrnce between the two other than the materrials that there made out of.
neppo1345
09-20-2006, 06:10 PM
Nope...Same thing, different material.
back2integrity
09-20-2006, 06:42 PM
The RT valve cannot use the ULT, the X-valve can. You can pay someone to drill out the RT on/off hole to use the ULT though.
neppo1345
09-20-2006, 06:53 PM
The ULT will work in the newer R/T valves.
However, the classic r/t requires the drilling that back2integrity is talking about.
The classic valves can be identified easily due to the face that they get their air from a hole on the bottom versus the side.
randel
09-21-2006, 10:51 PM
well can a ult kit work with a clasic valve
Pneumagger
09-21-2006, 11:29 PM
it's hit or miss. some have luck, some don't. In either case... it increases the likelyhood of shortstroking alot, unless you have a skilled trigger pull.
For this reason, AGD does not condne the use of ULT in the Classic valves. You can however put an RT On/off in a classic valve and drop the trigger pull by nearly one half wieght :cheers:
randel
09-21-2006, 11:36 PM
ok thanks for the help guys
Pneumagger,
So you are saying, in a classic valve, I could just order the RT on/off and drop it in? Same pin length (.750)? No modifications to the valve or on/off?
I actually have an older AIR valve, would it be the same as a Classic?
egb groupie
09-22-2006, 09:34 AM
Pneumagger,
So you are saying, in a classic valve, I could just order the RT on/off and drop it in? Same pin length (.750)? No modifications to the valve or on/off?
I actually have an older AIR valve, would it be the same as a Classic?
I currently use the setup you are talking about, no problems at all dropping it in a classic, air, etc valve. The only problems I have had is getting some chuffing at higher rates of fire. Don't quite know if that is from the on/off, or just my trigger handling skills....
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.