View Full Version : Did I just kill my valve?
chinstrap
09-22-2006, 07:34 PM
So I'm having this problem where my trigger is springy, but the marker won't fire when I pull the trigger. I was messing around with the Level 10 carriers and velocity in an attempt to get it to work when the velocity adjuster stopped turning. Now I can't get it to turn either way.
For reference: it's a classic valve with level 10 bolt and a palmers sideline stabilizer attached so I can run CO2 on it.
you cant turn your velocity in or out? try it when its degassed
chinstrap
09-22-2006, 09:38 PM
you cant turn your velocity in or out? try it when its degassed
I just fixed it. I had to slap it around a little.
chinstrap
09-22-2006, 10:03 PM
By the way, would you have any insight as to why it's not firing? I've tried all sorts of spring/carrier/shim combinations with the velocity way up and the stab all the way up and I'm still not getting any love. I've been at it for 5 hours now. Going a little bonkers here.
Are intelliframe triggers not compatible with classic valves or something?
Danimal82
09-23-2006, 11:59 AM
Check your on off assembly, make sure its oiled well. Also try loosening the thumbscrew that holds the valve in. Did you just put the intelliframe on?
oledude
09-23-2006, 08:28 PM
Or the opposite with the screw. Make sure it's tightened with an alan wrench to beyond hand tight. One of my mags wouldn't fire if the screw wasn't tight like that.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.