Quick Intelliframe FYI

[blackduck]

On my mag i recently added the black blade intelliframe. I also use a CP Cradle and the Dye Foregrip. The grip is a little long and runs into that cradle and a few others such as PB. Just letting ya know if you have a similar setup, you might have to buy a shorter grip, i purchased a 32 degrees gas thru and it shortened it up a bit... tight fit but still works, cant ask for more. Just lettin ya know,

hope ya had a merry christmas

[TheTramp]

Thanks for the tip. I'm getting a Intelliframe soon so I'll make sure to check out the clearence.

[shupore]

I have that problem right now, with my stabilizer on my mag. so im just going to go buy the nw quick disconnect block from my local store, to clear the regulator. well I hope that helps

[blackduck]

link to any store that would have that? its a very tight fit, a small amount of extra space could be helpful, thanks

[shupore]

well this is their website http://www.nwpaintballproducts.com/
but I just came back from my store tonight and set it up. it cleared my reg by about half an inch. the quick disconnect is really nice too.

[blackduck]

thank you

[[NA]WARLORD]

Why not just buy KAPP automag fore grip extender? This will push foregrip 2" forward and is only 25.00 at Paintballgear.com, under automag upgrades in foregrip section.

[Smoken]

Another thing with the Intelliframe is that it wouldn't fit on my dad's mag which has a Benchmark foregrip.

[blackduck]

kapp foregrip extended would bring my grip out too far, i like the compactness of my mag... im mainly front and the smaller the better, it would work but its all based on preference, id just assume go wit the block