Board for an Xmag

[b2k2]

I just got an Xmag, problem is it is minus a board. I would like to get a new one, can any one offer any advice on:

where to find one
what kind to get
what software to use

thanks

[A-Tach-One]

Only new option at the momment I think is a stock AGD board. Contact Tunaman or buy a expensive stock new one from AGD themselves. If you get one then upgrade the software to XMod! Minimorlock is another option but I don't know if Curt finally got some more out there or not. If you go used, I would try contacting grazymoto here on AO and see if he has a stock board.

[Pneumagger]

There is only 1 kind of board for the emag/xmag

You can get it from the AGD store http://store.airgun.com/index.cfm?fuseaction=catalog.prodInfo&productID=150&categoryID=24
Do you need the solenoid too? http://store.airgun.com/index.cfm?fuseaction=catalog.prodInfo&productID=158&categoryID=24
Also, do you have the antichop daughterboard (located below the breech)? If not, don't worry, you can't buy them anywhere.

Then flash the latest Xmod software on it, or have someone else flash it for cheap. Always troll the BST for spare boards. :cheers:

HF GL DS KA

[A-Tach-One]

Oh and if you do need an ACE (AntiChopEye) board, again contact grazymoto here on AO. He should have a few more working ones ready soon. I recieved one from him last week!

[BigEvil]

Talk to Tunaman, he's got em in abundance and can install it for you too if needed.

[b2k2]

Thanks for the help guys :headbang: