Piranti
10-16-2006, 08:00 PM
Ok, I have just about aquired all of the pieces for my Pump Mag project, and I am looking to find or get into negotiations for the Milling and Annodizing I want done to my marker.
Now heres the Proposed setup:
1. Benchmark Single Trigger Frame (currently stock dust black)
3. Dallara Rail (currently appears to be polished raw aluminium)
4. Dallara Body (currently appears to be Raw polished aluminium)
5. RPG 15* asa (gloss black)
6. RPG gas through foregrip (gloss black)
or CP gas through foregrip (gloss Black)
7. 12g quick change adapter (gloss black)
8. WWA Phantom single peice 10rnd feedtube (raw or gloss black)
9. Pump kit.
I have decided to go with a basic dust black theme on everything, so the previously annoed peices will need to be stripped and reannoed.
So what needs to be done is I need the rail and body milled to accept the Pump kit, and a hole drilled and tapped to match the phantom single peice feed to the body. Then Everything Annoed to match.
I am looking for someone with a good quality work, good communication, and good turnaround. Last but not least someone of repute, really dont want to go down the route some have gone with some custom work and not seen a return for over a year and no communication.
So if you know someone or are that someone feel free to PM me with contact information so I can work a deal out and get this PumpMag gogging the agg kiddies :shooting: :eek: :D
Thanks,
Josh
Now heres the Proposed setup:
1. Benchmark Single Trigger Frame (currently stock dust black)
3. Dallara Rail (currently appears to be polished raw aluminium)
4. Dallara Body (currently appears to be Raw polished aluminium)
5. RPG 15* asa (gloss black)
6. RPG gas through foregrip (gloss black)
or CP gas through foregrip (gloss Black)
7. 12g quick change adapter (gloss black)
8. WWA Phantom single peice 10rnd feedtube (raw or gloss black)
9. Pump kit.
I have decided to go with a basic dust black theme on everything, so the previously annoed peices will need to be stripped and reannoed.
So what needs to be done is I need the rail and body milled to accept the Pump kit, and a hole drilled and tapped to match the phantom single peice feed to the body. Then Everything Annoed to match.
I am looking for someone with a good quality work, good communication, and good turnaround. Last but not least someone of repute, really dont want to go down the route some have gone with some custom work and not seen a return for over a year and no communication.
So if you know someone or are that someone feel free to PM me with contact information so I can work a deal out and get this PumpMag gogging the agg kiddies :shooting: :eek: :D
Thanks,
Josh