Pure Energy HP Reg

[Shingo]

I would like to increase the output pressure of my Pure Energy 68/4500 HP Tank. I found a 'Service & Rebuild Procedure' (http://www.pmipaintball.com/pdf/PE_manual.pdf) for the reg and wondered if it was possible to increase the output pressure on the reg by adding shims to the 'Belleville Springs'.

Has anyone done this?

~Shingo~

[Shingo]

Just got word from PMI about their HP Tanks:

"The maximum out-put pressure of our tanks is between 850 and 875psi the regulator will vent out of the 1.8k rupture disk if the pressure rises above this."


:cry:



~Shingo~

[Allfat]

Just got word from PMI about their HP Tanks:

"The maximum out-put pressure of our tanks is between 850 and 875psi the regulator will vent out of the 1.8k rupture disk if the pressure rises above this."


:cry:



~Shingo~
couldnt you replace the 1.8k rupture disc with a 3k rupture disc? Then add shims to your hearts content. I am not sure if this will work, but it might.

[Shingo]

Has anyone done this?

If I add shims to the Belleville Spring... would it increase the output pressure? how much do I shim to increase the output 50~100psi?

~Shingo~