Valve/sear Tolerance

[UnderCurrent]

I am looking into possibly getting a Dallara Rail, and I wanted to make sure I had the right sear. When I bought my gun used from my local paintball store, it had a minimag body and a ReTro valve. Does this mean that the sear is most likely a Classic/Minimag sear, or is there something else it probably would be? I dont know if there are only small difference in measurements or what not, but it looks like this:


http://img469.imageshack.us/img469/2381/ammmsearassyxf2.jpg (http://imageshack.us)


Any help is appreciated

[rb211]

That's a classic sear. If yours is the same, it will work in the Dallara rail.

[UnderCurrent]

yea, I knew that was a classic sear, I wasnt very clear, but what I was trying to ask was, if mine looks like that, does it have to be a classic sear? or is there any other sears that look similar but have slightly different measurements or anything?

[FinchMan]

your minimag probably came with a AM/MM rail, and therefore a classic sear. The dallara rail is based off of a AM/MM rail, so it should work fine.

[UnderCurrent]

yea, it is a CM/MM rail Im pretty sure, I just wasnt sure if a CM/MM sear would work with a ReTro valve, or if the saer had to be changed when you replaced the valve

[Lenny]

Sears depend only on the rail. So if you have an RT valve it'll work just fine. Post pics when it's completed! :D

[UnderCurrent]

Ok, thanks everyone, thats what I needed to know.


and ha, Im really looking forward to posting some pics, a little while ago I got the rest of my parts back from anodizing :cool: