RT- Air pouring from the barrel

[sixtoes1313]

I just got an RT in a trade. I put some oil in the ASA, and aired it up with a high output compressed air tank. The thing starts pouring air from the barrel. I looked though a couple pages of FAQ and found a good thread on taking the thing apart. So i did and cleaned/oiled all the o rings. Some of them looked to be a little tan/brownish, but seemed to seal up fine. Any reason for hte cause of the leak? I know this question was probly asked a million times but i couldnt find answers in 3 pages of threads or so. Thanks for your time-

[don miguel]

replace power tube orings

[nevtangle]

Do you know if it has the level 10 or level 7? The easiest way to tell is to slide the bolt and spring off and look at the power tube.

The level 10 has a hex type tip that can be tightened with a wrench. The Level 7 has a tip that has a groove that a coin can be used to tighten/loosen.

[sixtoes1313]

its a level 7, but i hve a lvl 10 that should be here tommorow or so.

[sixtoes1313]

K i just ordered a parts kit for an RT and some extra foamies hopefully i can rebuild it before friday and play sat