dcent
12-23-2006, 01:34 PM
so. can a pneumag be built using a cocker front end
it has a lpr, 3 way and something else
could the 3 way have one out take nipple sealed so that there is only the one in and one out instead of 2 out one in.
setup so that the pin/orings always have one air out on. could onew be pluged or do you
need it for the pneumag?
( R=oring 0=airout 2=airin)
--------------0--------------2---------------0--------
----------R------------------------------R---------------pin-------------
it has a lpr, 3 way and something else
could the 3 way have one out take nipple sealed so that there is only the one in and one out instead of 2 out one in.
setup so that the pin/orings always have one air out on. could onew be pluged or do you
need it for the pneumag?
( R=oring 0=airout 2=airin)
--------------0--------------2---------------0--------
----------R------------------------------R---------------pin-------------