Toll
01-30-2007, 07:59 PM
I figured I may as well ask now, rather than have a headache later
I finally got the pnuemag guts to fit inside of the shocker frame with only a wee bit of filing/etc The problem is that the valve screw hole is about 1/16th of an inch off of where it would be normally. The valve still fits on, how ever it is farther back than it would normally be and it is rather noticeable. Would this cause an issue with the pin/seer?
Just curious.
I finally got the pnuemag guts to fit inside of the shocker frame with only a wee bit of filing/etc The problem is that the valve screw hole is about 1/16th of an inch off of where it would be normally. The valve still fits on, how ever it is farther back than it would normally be and it is rather noticeable. Would this cause an issue with the pin/seer?
Just curious.