Pneumag LPR?

[zipity_Bop]

Which LPR should i get?
i'm on a budget and i want one that is good for a pneumag?

[Automagrt666]

The Tickler LPR isn't too expensive and very, very nice. You can get em for like 40 on ebay last time I checked. And if that is too expensive for you, I guess you could prolly hunt down some stock WGP ones from like a prostock or something. I'm going to be using an 05' prostock's LPR in my pneumag and it's pretty small I must say. I'm sure there are a bunch of em that are pretty cheap, have you tried looking around the tech and workshop areas?

Nick

[latches109]

i found ticklers to creep up in pressure.

[Pneumagger]

i found ticklers to creep up in pressure.
replace the reg seat/clean it. if anything it should back out after firing alot and go down.

[olinar]

if youre going to run it on the vertical adapter i have one thatll work for ya.wont fit in a frame tho.

[latches109]

replace the reg seat/clean it. if anything it should back out after firing alot and go down.

thanks, will do. I was getting tired of adjusting it every so often. I probably still end up getting a palmers micro rock eventually.

[Pneumagger]

thanks, will do. I was getting tired of adjusting it every so often. I probably still end up getting a palmers micro rock eventually.

I had a microrock that would creep on me and that ended up being the problem.

[shorty24]

I had a microrock that would creep on me and that ended up being the problem.

Do the ticklers have a set screw then? I was thinking about getting a microrock, but yeah, I've heard they tend to back out.