micromag-sear pin-sear

[dizzle]

whats up all?kinda new here and have a question.
i have a vert feed micromag that i am planning to hyperframe.i was told to use a am/mm sear.the screw in sear pin that came with the body i just barely too big in diameter to go in the sear.do i need a different pin?or does the sear pin need to be tapped in?thanks in advance

[flyingpootang]

Hmmm, A am/mm pin shoud drop right in. I would avoid hammering it in because getting it out would be a bear. I would either try a different sear or have the one you have drilled to fit.

[dizzle]

got it!thanks bro.i ran a 3/16 drill bit through it by hand.its a brand new sear from AGD.its still pretty tight as far as pivoting,maybe just need to cycle it by hand to "break it in".

[MANN]

edit: I mis read your first post. Yes a normal am/mm sear is what is needed.

[dizzle]

thanks to both for your help! :cheers: