PDA

View Full Version : 3 balls a shot


PhantomStalker
02-22-2007, 05:58 PM
my mag somaetimes shoots out 3 balls at a time. how can i fix this?
don miguel
02-22-2007, 06:00 PM
on/off pin problem most likely. ellaborate on your setup.
PhantomStalker
02-22-2007, 06:03 PM
68 classic warp feed, revy hopper, dye barrel, 72/3k tank, maxflow reg, air valve. and what is the onn/off pin?
MoeMag
02-22-2007, 06:07 PM
Is it shooting 3 times for every pull

or

Is it shooting once, and 3 balls come out.

If the first, don miguel is prob right and ignore me.

If it is the second, the ball detent needs some help. It may not be strong enough and the warp is over feeding it.
PhantomStalker
02-22-2007, 06:09 PM
it not doing it on every pull. about every 2 or 3 puls but its 3 balls one pull
MoeMag
02-22-2007, 06:11 PM
it not doing it on every pull. about every 2 or 3 puls but its 3 balls one pull

Then its your ball detent.

twist lock or ule body?
PhantomStalker
02-22-2007, 06:15 PM
its a twistlock. the detents are the same as nubbins right?
Jaan
02-22-2007, 06:17 PM
Detent/Nubbin
PhantomStalker
02-22-2007, 06:18 PM
ok thanks guys
Greg2230
02-22-2007, 09:47 PM
Detent for sure...
snoopay700
02-24-2007, 03:36 AM
Your velocity could be way too high, that is if the gun fires 3 consecutive times, this happened to me a while back.
PhantomStalker
02-24-2007, 11:00 AM
it was the detent i got it fixed
snoopay700
02-24-2007, 02:49 PM
it was the detent i got it fixed
Ok, well that's good, i just realized that it might've been the same thing that happened to me.
Thotograph
02-25-2007, 05:30 PM
be sure to have a couple extra nubbins in your gear bag just in case you run into this again b/c the warp (i imagine) needs a pretty strong/fresh detent to provide the right kind of resistance... also if you have extras then you can be that guy who helps out a fellow mag owner in their time of need... and make a little dough off of a cheap piece of plastic.

i had a similiar problem in one of my guns but it was with a halo... all forcefeed hoppers need a proper detent...

i'm thinkin double detents doesn't sound all that bad for my ule body... hmmmmm. fyi some of the older twistlock barrels actually had slots for two nubbins. i think i had a black alluminum dye that had that once... might be something to check out...