Classic valve fit on RT Pro rail?

[Greg2230]

Can I put a RT-Pro rail on my classic ULEd mag? Thanks

[Madmarx]

Yes sir.

[Greg2230]

Yeah, but from the picture, it looks like my sear will not work as there is nowhere to put it. Here is a picture of it.
http://i17.ebayimg.com/07/i/000/8f/a4/9ca7_12.JPG

[Greg2230]

up

[punkncat]

You will need an RT sear rather than the "Classic" (am/mm) sear.

Who did that rail?

[Greg2230]

I reallly am not sure. I didnt buy it, I was thinking about it though. So I can use an RT sear on a classic valve?

[ta2maki]

Yes. What you would need to use that rail on a 'classic' AM/MM would be 1) a RT sear and 2) a RT sear pin. Unlike the AM/MM rail(where the sear and pin drop in), the sear is located by a pin that screws in from the side and 'bolts' the sear to the body.

[pennywise]

I reallly am not sure. I didnt buy it, I was thinking about it though. So I can use an RT sear on a classic valve?
All of the valves are compatible with all of the rails and sears (edit: except for the original RT valve/rail); however, not all of the rails and sears are compatible with each other.

[Greg2230]

Thanks a lot fellas :cheers: